Prerequisites You should have installed and configured Eucalyptus before starting the CLC.
To initialize and start the CLC
Log in to the Cloud Controller (CLC) host machine. Enter the following command to initialize the CLC:
Note
If you are upgrading and you just restored your cloud data, do not initialize the CLC; skip this step.Note
Make sure that the process is running before executing this command.clcadmin-initialize-cloud
This command might take a minute or more to finish. If it fails, check /var/log/eucalyptus/cloud-output.log . If you want the CLC service to start at each boot-time, run this command:
systemctl enable eucalyptus-cloud.service
Enter the following command to start the CLC:
systemctl start eucalyptus-cloud.service
If you are running in VPCMIDO networking mode: If you want the eucanetd service to start at each boot-time, run this command:
systemctl enable eucanetd.service
Start the eucanetd service:
systemctl start eucanetd.service