Start the NC

Prerequisites You should have installed and configured Eucalyptus before starting the NC.

To start the NC

Log in to the Node Controller (NC) host machine. If you want the NC service to start at each boot-time, run this command:

systemctl enable eucalyptus-node.service

Enter the following command to start the NC:

systemctl start eucalyptus-node.service

If you are running in EDGE networking mode: If you want the eucanetd service to start at each boot-time, run this command:

systemctl enable eucanetd.service

Start the eucanetd service:

systemctl start eucanetd.service

Repeat for each NC host machine.